Download PDF Manual:
Etekcity Remote Control Outlet Wireless Light Switch.pdf 
Full Text of Manual:
tekcity 3 Pack Remote Control Outlets Wireless Light Switches for Household Appliances, Unlimited Connections, FCC ETL Listed, White (1 Remotes Included)
LED INDICATION LIGHT
PROGRAMMING BUTTON
ESSENTIALS E T E K C I T Y
Notes
– Regularly change the battery in the remote control for best
performance. If you find the outlet switches are not responding or the
LED indicator on the remote control becomes dim, the battery should
be replaced. Always dispose of old batteries properly with
consideration for the environment.
– Make sure the battery and outlets are installed firmly and correctly for
safe operation.
– These outlet switches are for indoor use only. Avoid exposure to high
temperature sources, strong sunlight, and moisture. The outlets are
best used in areas with good air circulation.
– Do not exceed the maximum load current of 10A (approximately
1200W).
– Extra buttons on remotes can be used with additional outlets.
ZAP POINT. CLICK
L-Series
. POWER.
Setup
– Install one 12V/23A battery in the remote control’s battery
compartment, making sure the polarity of the battery is correct.
– Plug each outlet switch into a socket and plug a device or appliance
into each outlet.
– Press the on/off buttons for the respective channel on the remote
control to operate the outlet switch.
Features
– Easily controlled by the remote control from up to 100 feet in
line-of-sight
– Separate on and off buttons on the remote control
– Can be switched on and off manually by pressing the programming
button on the side of the outlet
– Programmable – program any outlet to any button
– Extra outlets and remotes can be purchased separately for easy
expansion of the set
– Outlets will remain powered off after a power outage to save energy
– Power output up to 1200W at 120V (60Hz)
– Low power consumption, reduces energy use and extends product life
by up to 15%
Programming the outlets
Note. The outlets are pre-programmed for immediate use, but the
configuration can be customized to meet your needs.
To program a remote control transmitter and outlet switch receiver:
– Plug the outlet switch into a socket and turn it on.
– Press and hold the programming button on the right side of the outlet
until the LED indicator begins to flash.
Release the programming button and then press the desired On or Off
button on the remote.
– The pairing is successful when the LED indicator stops flashing.
Technical data
Voltage……………………………………………………………..120V~/60Hz
Max. power………………………………………………………………..1200W
Max. current……………………………………………………………………iqa
Transmission frequency……………………………………. 433.92MHz
Remote battery……………………………………………………. 12V (23A)
Intertek
3159168
C0NF0RMST0 ULSTD 61058-1 AND 498A
CERTIFIEDTO CSA STD.C22.2 NO. 61058-1 AND42
Resetting an outlet (cancel all pairings)
To cancel all pairings so that no remote control will control it:
– Remove the outlet from the power socket.
– Press and hold the programming button.
Plug the outlet back into the power socket while continuing to hold
the programming button.
– Hold the programming button for approximately 5 seconds until the
LED indicator begins to flash.
– When the LED flashes rapidly several times and stops, the outlet has
been reset. Etekcity Remote Control Outlet Wireless Light Switch